Posted on

sE1X tames the beast known as Polycarbonate!

DSC00410

So after much trial and error, we finally found what works for adhesion when printing PC! 😀

So with the heated bed set to 120c, some kapton tape roughed up with sandpaper, and a thin layer of ABS juice, we’ve managed to get great adhesion when printing the beast, Polycarbonate and will hopefully be able to start offering polycarbonate printed parts with our sE1X kits!

Hotend: Hexagon AO

Temp: 285c (bed@120c)

Speed: 40mm/s

DSC00410 DSC00412

Share and Enjoy

  • Facebook
  • Twitter
  • Delicious
  • LinkedIn
  • StumbleUpon
  • Add to favorites
  • Email
  • RSS

Leave a Reply

Your email address will not be published. Required fields are marked *