Posted on

sE1X latest print results look promising!

DSC00844

So after months of grueling work to get the sE1X design finished and ready for sale’s, I finally can see some light at the end of the tunnel! I have had my ups and downs along the way, not to mention self doubt founded from constant criticism, but I stuck to it and I’m proud to call the sE1X evolution my own. This has been a great starting point for me and I have learned and evolved myself and would like to officially announce my plans to build my own 3d printer design, from scratch. Once I have this set in stone, I will reveal more about it, until then…enjoy some sE1X printer pron:

Polygon Vase (thingiverse)

Printed using ‘Spiral Vase’ mode in Slic3r using Atomic Filament’s Orange PLA.

Layer Height: .4mm

Print Temp: 210-205

Print Speeds: Rough Avg. of 50 mm/s

DSC00843 DSC00845 DSC00846

Share and Enjoy

  • Facebook
  • Twitter
  • Delicious
  • LinkedIn
  • StumbleUpon
  • Add to favorites
  • Email
  • RSS

Leave a Reply

Your email address will not be published. Required fields are marked *