Posted on

sE1X v1.5 VS. Fortus 450mc !!!!

DSC00563

Check out the amazing results below Chris Morewood was able to get with his sE1X v1.5(Running on a Smoothieboard 5xc). In the picture you’ll notice he points out a small flaw with the infill and the perimeters not quite touching in 2 spots but I think this is more a slicer config setting then the 3d printer/control board itself.

Thank you very much Chris ‘ChrisM37’ Morewood for this awesome comparison work and I look forward to seeing your future prints!!! Well done. 🙂

THE COMPARISON PHOTOS:
https://goo.gl/j3EzBr

Share and Enjoy

  • Facebook
  • Twitter
  • Delicious
  • LinkedIn
  • StumbleUpon
  • Add to favorites
  • Email
  • RSS

Leave a Reply

Your email address will not be published. Required fields are marked *