Posted on

How to address the issues..Magma hotend (3mm-0.4mm)

LoHs magma demo

The Magma hot-end has gotten a very bad rep because of poor performance most likely from the job being rushed to try and save TrinityLabs LLC. If you happen to be oen of the ones to end up with a Magma hot-end and want to try and get it to function properly, well here is a walk-through of what another member in the Reprap community put together for it.

DSC01001 The Magma hot-end, broke down into 4 parts.DSC00998 The Magma assembled.

The Walk-through documentation linkhttp://hastebin.com/aleyefumis.vhdl (Thank you LoH for doing the research, much appreciated.)

Share and Enjoy

  • Facebook
  • Twitter
  • Delicious
  • LinkedIn
  • StumbleUpon
  • Add to favorites
  • Email
  • RSS
Posted on

sE1X v1.5 VS. Fortus 450mc !!!!

DSC00563

Check out the amazing results below Chris Morewood was able to get with his sE1X v1.5(Running on a Smoothieboard 5xc). In the picture you’ll notice he points out a small flaw with the infill and the perimeters not quite touching in 2 spots but I think this is more a slicer config setting then the 3d printer/control board itself.

Thank you very much Chris ‘ChrisM37’ Morewood for this awesome comparison work and I look forward to seeing your future prints!!! Well done. 🙂

THE COMPARISON PHOTOS:
https://goo.gl/j3EzBr

Share and Enjoy

  • Facebook
  • Twitter
  • Delicious
  • LinkedIn
  • StumbleUpon
  • Add to favorites
  • Email
  • RSS
Posted on

Theundeadelvis gets dialed in..

Kick ass scorpion, one of his first big prints.

This is a collection of some of the recent accomplishments from our friend/customer theundeadelvis(as he goes by on IRC). He has been a really great guy to work with and I always look forward to seeing what hes made with his sE1X..needless to say, I am always proudly impressed!

 

Now for the pron:

theundeadelvis rad x end pic

Beautiful X motor end in red ABS
Beautiful X motor end in red ABS
Beautiful smoothieboard case!
Beautiful smoothieboard case!
Kick ass scorpion, one of his first big prints.
Kick ass scorpion, one of his first big prints.
That chain is off the chain! :)
That chain is off the chain! 🙂

Looking forward to seeing what you make next TUE(theundeadelvis)!

Share and Enjoy

  • Facebook
  • Twitter
  • Delicious
  • LinkedIn
  • StumbleUpon
  • Add to favorites
  • Email
  • RSS